Click here To See All Auxiliary Equipment
The CF-A Series Portable Chiller provides precise temperature control from an economically affordable and reliable unit. Perfect for plastic injection molding, blow molding, extrusion and other industrial applications.
An economical and reliable unit for heat exchange, the CF-W Series (Water-cooled) and CF-A (Air-Cooled) Portable Chillers utilize a single refrigerant zone with a compressor and evaporator, along with an insulated reservoir and a coolant pump. The Air-cooled models (CF-A) use fans or blowers to move ambient air across the condenser.
Chiller control instrumentation on the units include; microprocessor controller, large temperature and machine status displays, power, coolant pump and compressor status indicators, and on/off rocker switch.
Each unit has a coolant freezestat, compressor motor overload protection, refrigerant high and low pressure switches, and instrument control circuit fuse for safety.
The major benefits of the CF-A Series Portable Chillers are recommended for applications where inadequate or contaminated water supplies exist, or where heat recovery for supplemental heating is desired.
1 Tons Capacity at 12,000 BTU/ton @ 50°F LWT @ 105° F Condensing Temperature. (Capacity may be +/- 5%)
2 H- Hermetic compressor, S - Semi-Hermetic Compressor
3 Static Pressure in inches of water
4 Full Load Amperage shown. No allowance for in-rush. Full Load Amps are higher than Run Load Amps and must be used for sizing disconnects and supply wiring.
Home | Request a Quote | Place an Order | Product Index | Online Catalog |
Barrels & Screws | Electrical Products | Hoses & Fittings |
Molding Accessories | SDS Sheets | Credit Application | Terms & Conditions | About Us | Contact Us
7925 N. Clinton St., Fort Wayne, IN 46825-3113, USA
Contact Webmaster regarding content or link problems
Copyright 1997-2023 Services For Plastics, Inc. All rights reserved.